Pulsatile flow

In fluid dynamics, a flow with periodic variations is known as pulsatile flow, or as Womersley flow. The flow profiles was first derived by John R. Womersley (1907–1958) in his work with blood flow in arteries.[1] The cardiovascular system of chordate animals is a very good example where pulsatile flow is found, but pulsatile flow is also observed in engines and hydraulic systems, as a result of rotating mechanisms pumping the fluid.

Equation

Four pulsatile flow profiles in a straight tube are shown. The first graph (in blue) shows the pressure gradient as a cosine function, and the other graphs (in red) show dimensionless velocity profiles for different Womersley numbers.

The pulsatile flow profile is given in a straight pipe by

where:

uis the longitudinal flow velocity,
ris the radial coordinate,
tis time,
αis the dimensionless Womersley number,
ωis the angular frequency of the first harmonic of a Fourier series of an oscillatory pressure gradient,
nare the natural numbers,
P'nis the pressure gradient magnitude for the frequency ,
ρis the fluid density,
μis the dynamic viscosity,
Ris the pipe radius,
J0(·)is the Bessel function of first kind and order zero,
iis the imaginary number, and
Re{·}is the real part of a complex number.

Properties

Womersley number

The pulsatile flow profile changes its shape depending on the Womersley number

For , viscous forces dominate the flow, and the pulse is considered quasi-static with a parabolic profile. For , the inertial forces are dominant in the central core, whereas viscous forces dominate near the boundary layer. Thus, the velocity profile gets flattened, and phase between the pressure and velocity waves gets shifted towards the core.

Lower limit

The Bessel function at its lower limit becomes[2]

which converges to the Hagen-Poiseuille flow profile for steady flow for

or to a quasi-static pulse with parabolic profile when

In this case, the function is real, because the pressure and velocity waves are in phase.

Upper limit

The Bessel function at its upper limit it becomes[2]

which converges to

This is highly reminiscent of the Stokes layer on an oscillating flat plate, or the skin-depth penetration of an alternating magnetic field into an electrical conductor. On the surface , but the exponential term becomes negligible once becomes large, the velocity profile becomes almost constant and independent of the viscosity. Thus, the flow simply oscillates as a plug profile in time according to the pressure gradient,

However, close to the walls, in a layer of thickness , the velocity adjusts rapidly to zero. Furthermore, the phase of the time oscillation varies quickly with position across the layer. The exponential decay of the higher frequencies is faster.

Derivation

For deriving the analytical solution of this non-stationary flow velocity profile, the following assumptions are taken:[3][4]

Thus, the Navier-Stokes equation and the continuity equation are simplified as

and

respectively. The pressure gradient driving the pulsatile flow is decomposed in Fourier series,

where is the imaginary number, is the angular frequency of the first harmonic (i.e., ), and are the amplitudes of each harmonic . Note that, (standing for ) is the steady-state pressure gradient, whose sign is opposed to the steady-state velocity (i.e., a negative pressure gradient yields positive flow). Similarly, the velocity profile is also decomposed in Fourier series in phase with the pressure gradient, because the fluid is incompressible,

where are the amplitudes of each harmonic of the periodic function, and the steady component () is simply Poiseuille flow

Thus, the Navier-Stokes equation for each harmonic reads as

With the boundary conditions satisfied, the general solution of this ordinary differential equation for the oscillatory part () is

where is the Bessel function of first kind and order zero, is the Bessel function of second kind and order zero, and are arbitrary constants, and is the dimensionless Womersley number. The axisymetic boundary condition () is applied to show that for the derivative of above equation to be valid, as the derivatives and approach infinity. Next, the wall non-slip boundary condition () yields . Hence, the amplitudes of the velocity profile of the harmonic becomes

where is used for simplification. The velocity profile itself is obtained by taking the real part of the complex function resulted from the summation of all harmonics of the pulse,

Flow rate

Flow rate is obtained by integrating the velocity field on the cross-section. Since,

then

Velocity profile

Scaled velocity profiles of pulsatile flow are compared according to Womersley number.

To compare the shape of the velocity profile, it can be assumed that

where

is the shape function.[5] It is important to notice that this formulation ignores the inertial effects. The velocity profile approximates a parabolic profile or a plug profile, for low or high Womersley numbers, respectively.

Wall shear stress

For straight pipes, wall shear stress is

The derivative of a Bessel function is

Hence,

Centre line velocity

If the pressure gradient is not measured, it can still be obtained by measuring the velocity at the centre line. The measured velocity has only the real part of the full expression in the form of

Noting that , the full physical expression becomes

at the centre line. The measured velocity is compared with the full expression by applying some properties of complex number. For any product of complex numbers (), the amplitude and phase have the relations and , respectively. Hence,

and

which finally yield

See also

References

  1. Womersley, J.R. (March 1955). "Method for the calculation of velocity, rate of flow and viscous drag in arteries when the pressure gradient is known". J. Physiol. 127 (3): 553–563. doi:10.1113/jphysiol.1955.sp005276. PMC 1365740. PMID 14368548.
  2. Mestel, Jonathan (March 2009). "Pulsatile flow in a long straight artery" (PDF). Imperial College London. Retrieved 6 January 2017. Bio Fluid Mechanics: Lecture 14
  3. Fung, Y. C. (1990). Biomechanics – Motion, flow, stress and growth. New York (USA): Springer-Verlag. p. 569. ISBN 9780387971247.
  4. Nield, D.A.; Kuznetsov, A.V. (2007). "Forced convection with laminar pulsating flow in a channel or tube". International Journal of Thermal Sciences. 46 (6): 551–560. doi:10.1016/j.ijthermalsci.2006.07.011.
  5. San, Omer; Staples, Anne E (2012). "An improved model for reduced-order physiological fluid flows". Journal of Mechanics in Medicine and Biology. 12 (3): 125–152. arXiv:1212.0188. doi:10.1142/S0219519411004666.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.